Trampoline Installation Instruction
4 – FRAME SECTIONS
4 – U SHAPED LEGS
1 – BOX OF SPRINGS
1 – JUMP BED
1 – FRAME PAD
Step 1. Lay out the 4 frame sections in a circle with the leg stubs facing the ground. Do not connect the joints.
Step 2. Insert legs into the leg stubs but do not connect the frame joints. The legs go across the joints.
Step 3. Once standing, to get the joints together, put a foot on the leg, grab on each side of the joint and pull back. Put the reduced end inside the larger end and push away. Repeat for other joints.
Step 4. Spread out the jump bed on the ground inside the frame. Attach a spring to the jump bed v-ring first, then to the frame. Attach every 10th spring the first time around the trampoline.
On the second round, add 2 springs next to the original 10.
Repeat adding 2 springs to each area, working around the trampoline 4 more times.
Step 5. Before adding the last 10 springs, spread the frame pad on the trampoline, putting the seams of the pad over the area where the last springs are to be attached. Place the spring through the inner loop on the bottom side of the pad, then tie to the frame with the outer ties. Make sure pad warning label is visable.
Step 6. Place the two warning labels on upright part of leg on opposite sides of trampoline.
Step 7. Jump safely and have fun.